Fordson Dexta
Engine Kits - Fordson Dexta
Engine Kits - FORDSON DEXTA GASOLINE MODEL

Now available with a NEW CRANKSHAFT for little more than a basic regrind for most applications
Dexta Gas. uses STANDARD MOTOR Co. Ferguson UK MF35 Engine (87 mm bore)
3 KIT LEVELS
"EK" - FOR IN-FRAME REPAIR. Includes - Pistons, Wrist Pin Bushes, Piston Rings, Liners, Con Rod Bearings, Top & Bottom Gasket Sets.

"EKM" - FOR OUT OF FRAME REBUILD. Includes ALL of the above PLUS - Main Bearings (you specify under-size required at NO EXTRA COST), Thrust Washers, Front & Rear Seals.

"EKMC" - same as EKM but INCLUDING A NEW CRANKSHAFT

IMPORTANT
To reduce your Inventory levels, Bare-Co lists VALVE TRAIN KITS separately below the Engine Kit Part Numbers. Valve Train Kits will fit a range of different engine kits.

 

APPLICATION
ENGINE
KIT
PISTON/ LINER
(1 CYL)
RING SET
(1 CYL)
PISTON
LINER
FINISHED
LINER SEMI
FINISH
Fordson Dexta Gasoline
87mm bore
EK3
EKM3
EKMC3
B2143
B2616
B6143
B7538
=825861M1
N/R
NOTE: Parts shown are BARE-Co parts - original part numbers are shown for reference only.