Ford Gas Engine Kits & Comp
Engine Kits - Ford Gas Models |
|
|
Engine Kits - FORD GASOLINE MODEL
|
Now available with a NEW CRANKSHAFT for little more than a basic regrind for most applications |
|
"EK" - FOR IN-FRAME REPAIR. Includes - Pistons, Wrist Pin Bushes, Piston Rings, Liners, Con Rod Bearings, Top & Bottom Gasket Sets.
"EKM" - FOR OUT OF FRAME REBUILD. Includes ALL of the above PLUS - Main Bearings (you specify under-size required at NO EXTRA COST), Thrust Washers, Front & Rear Seals.
"EKMC" - same as EKM but INCLUDING A NEW CRANKSHAFT
To reduce your Inventory levels, Bare-Co lists VALVE TRAIN KITS separately below the Engine Kit Part Numbers. Valve Train Kits will fit a range of different engine kits.
|
|
APPLICATION
| ENGINE KIT
| PISTON
| RING SET
(1 CYL)
| LINER
| CON ROD BEARINGS
| WRIST PIN BUSH
|
9N, 2N, 8N
3 3/16" bore with .040" wall thickness liner (3.269"O.D.) CONFIRM LINER THICKNESS BEFORE ORDERING - BOTH TYPES USED
|
| B2742
3 ring piston
=
8N6108B
| B2743
fits 3 ring piston ONLY
=
8N6149G
| B2719
.040" wall thickness
=
CONN6055B
|
B2734
= CRK9N6211A |
STD |
B2735
= CRK9N6211E |
- .010"u/s |
B2736
= CRK9N6211G |
- .020"u/s |
B2737
= CRK9N6211-30 |
- .030"u/s |
|
|
9N, 2N, 8N
3 3/16" bore with .090" wall thickness liner (3.367"O.D.) CONFIRM LINER THICKNESS BEFORE ORDERING - BOTH TYPES USED
|
| B2720
.090" wall thickness
=
8N6055B
|
134 cu. inch Gas Engine
3.4375" bore |
1953 to 1957
7/16" Head Studs
NAA, 600, 700
|
|
|
|
| FULL SET
B1734
= CRK312026STD |
STD |
B1735
= CRK312026-010 |
- .010"u/s |
B1736
= CRK312026-020 |
- .020"u/s |
B1737
= CRK312026-030 |
- .030"u/s |
|
|
134 cu. inch Gas Engine
3.4375" bore |
1958 to 1964
1/2" Head Studs
501, 601, 701, 2000
|
|
172 cu. inch Gas Engine
3.9" bore |
1955 to 1964
800, 900, 801, 901
4000 up to 1964
|
|
|
|
|
Engine Kits - Ford Gas Models |
|
|
NOTE: Parts shown are BARE-Co parts - original part numbers are shown for reference only.
|